( File-Name: DE09Y-RE.CNC @ 23/01/06
( REAR/Reverse/Recess for 3mm panel install of DE09 shell in Rack Panels
( Set start reference datum at x0000, y0000 - top hole datum centre
( Install 5mm Long/Short series Slot Drill or FC3 End Mill
( the travel concludes when the cutter reaches x=0.00; y=0.00
( Spindle speed set to 2500rpm
( operation begins automatically when quill TDC switch is open
( raise the quill at the end of the X-0000 & Y 0000mm stroke
( when appropriate, use a manual command the "X" axis to the
( PITCH distance between each consecitive hole in patch panels etc.
( 80% Kero+ 20% RTD is used as cutting lubricant during the cutting stroke
clr	  	( clear all existing programms/commands
clr	  	( clear all existing programms/commands
p 	  	( programme begin
m 1	  	( set motor to FULL step mode
t 100	  	( set start speed to 100 steps/sec
max 300 	( set MAXimum speed to steps per sec. i.e. 500steps/sec
a 300	  	( set acceleration to 100 steps/sec/sec
de 300	( set deceleration to 300 steps/sec/sec
k 50		( sets step constant to 50 ?
s 4 0		( check that the TDC switch is closed
s 4 1 	( check BDC switch OPEN - mill may be cycling or at TDC
o 1 1        ( mist ON
w 30		( wait 1/2 sec. - allows plunge quill and penetrate sheet
<snip>
o 1 0		( turn OFF mist/spray
s 4 0		( check that the TDC switch is closed
g
q