( Krypton Interrupter zener heatsink - screw holes - top
( Set start reference datum at x-1000, y5000
( Install 3.2~3.5mm Fast Spiral Drill or similar
( Spindle speed set to 2500~3000rpm
( operation begins automatically when quill TDC switch is opened
( raise the quill at the end of the last X+zzzmm stroke
( with appropriate care the part can be remove the part during the parked condition
( 80% Kero+ 20% RTD used as cutting lubricant during the X+13100mm cutting stroke
( return speed may be increased if justified by higher production rate
clr		( clear all existing programs/commands
p		( begin programme
m 1		( set motor to FULL step mode
t 200		( set start speed to 200 steps/sec
max 400	    ( set MAXimum motor speed to steps per sec. i.e. 400 steps/sec
a 500		( set acceleration to 500 steps/sec/sec
de 500      ( set deceleration to 1500 steps/sec/sec
k 50        ( sets step constant to 50 ?
s 4 0           ( BDC switch OPEN - press is cycling or at TDC
x 1050          ( move "x" axis +10.50mm
y 400           ( move "y" axis 4.00mm
o 1 1
s 4 1           ( check that the TDC switch is closed
s 4 0           ( BDC switch OPEN - press is cycling or at TDC
o 1 0
x 6000
o 1 1
s 4 1           ( check that the TDC switch is closed
s 4 0           ( BDC switch OPEN - press is cycling or at TDC
o 1 0
x -1000
y 2100
o 1 1
s 4 1           ( check that the TDC switch is closed
s 4 0           ( BDC switch OPEN - press is cycling or at TDC
o 1 0
x -1000
o 1 1
s 4 1           ( check that the TDC switch is closed
s 4 0           ( BDC switch OPEN - press is cycling or at TDC
o 1 0
x 2000
y 2100
o 1 1
s 4 1           ( check that the TDC switch is closed
s 4 0           ( BDC switch OPEN - press is cycling or at TDC
o 1 0
x -6000
o 1 1
s 4 1           ( check that the TDC switch is closed
s 4 0           ( BDC switch OPEN - press is cycling or at TDC
o 1 0
x 1000
y -2100
o 1 1
s 4 1           ( check that the TDC switch is closed
s 4 0           ( BDC switch OPEN - press is cycling or at TDC
o 1 0
x -2050
y -2500
s 4 1           ( check that the TDC switch is closed
s 4 0           ( BDC switch OPEN - press is cycling or at TDC
c 0             ( turn motor current off
g               ( go to begining and repeat as often as job/parts require