( Krypton heatsink mount - industrial formica - short - 63 mm long piece
( Set start reference datum at x-1000, y5000
( Install drill 2.5mm for M3 tapped holes
( Spindle speed set to 2500rpm
( operation begins automatically when quil TDC switch is opened
( raise the quill at the end of the last X+zzzmm stroke
( with appropriate care the part can be remove the part during the parked condition
( 80% Kero+ 20% RTD used as cutting lubricant during the X+13100mm cutting stroke
( return speed may be increased if justified by higher production rate
clr             ( clear all existing programms/commands
p               ( begin programme
m 1             ( set motor to FULL step mode
t 200           ( set start speed to 300 steps/sec
max 400         ( set MAXimum motor speed to steps per sec. i.e. 1500 steps/sec
a 500           ( set acceleration to 1500 steps/sec/sec
de 500          ( set deceleration to 1500 steps/sec/sec
k 50            ( sets step constant to 50 ?
s 4 1           ( check that the TDC switch is closed
s 4 0           ( BDC switch OPEN - press is cycling or at TDC
x 600           ( move "x" axis +6.00mm
s 4 1           ( check that the TDC switch is closed
s 4 0           ( BDC switch OPEN - press is cycling or at TDC
x 3800
s 4 1           ( check that the TDC switch is closed
s 4 0           ( BDC switch OPEN - press is cycling or at TDC
x 600
s 4 1           ( check that the TDC switch is closed
s 4 0           ( BDC switch OPEN - press is cycling or at TDC
c 0
s 4 1
s 4 0
x -600
s 4 1
s 4 0
x -3800
s 4 1 
s 4 0
x -600
s 4 1
s 4 0
c 0             ( turn motor current off
g               ( go to begining and repeat as often as job/parts require