( HS-TH-KR.TXT modified 21-08-06
( Krypton Interrupter combined heatsink - top screw holes
( for clamping top, middle and bottom
( total drilling depth is 35 mm - for 30 mm screws
( [top and two centre layers later drilled out to 3.3 mm]
( Set start reference datum at x+3200, y+930 with 6.3mm packing
( Install #36 (2.65mm) drill for later Roll Form Tapping M3
( Spindle speed set to 2500~3000rpm
( operation begins automatically when quil TDC switch is opened
( raise the quill at the end of the last stroke
( with appropriate care the part can be removed during the parked condition
( 80% Kero+ 20% RTD used as cutting lubricant
( .
( datum is x = 32 mm, y = 3 mm
clr		( clear all existing programs/commands
p		( begin programme
m 1		( set motor to FULL step mode
t 200		( set start speed to 200 steps/sec
max 900	( set MAXimum motor speed to steps per sec. i.e. 400 steps/sec
a 1200		( set acceleration to 500 steps/sec/sec
de 1200      ( set deceleration to 1500 steps/sec/sec
k 50        ( sets step constant to 50 ?
s 4 0           ( BDC switch OPEN
s 4 1           ( check that the TDC switch is closed
o 1 1           ( mist lubrication on
s 4 0           ( BDC switch OPEN
o 1 0           ( mist lubrication off
x 10040          ( move "x" axis 100.4 mm
s 4 1           ( check that the TDC switch is closed
o 1 1
s 4 0           ( BDC switch OPEN
o 1 0
y 5450
s 4 1           ( check that the TDC switch is closed
o 1 1
s 4 0           ( BDC switch OPEN
o 1 0
x -10040
s 4 1           ( check that the TDC switch is closed
o 1 1
s 4 0           ( BDC switch OPEN
o 1 0
y -5450
c 0             ( turn motor current off
g               ( go to begining and repeat as often as job/parts require
q