( HS-ZE-KR.TXT 26/8/2006
( Krypton Interrupter combined heatsink - Zener Rebate
( for end wiring termination/link between Zeners
( .
( install vertical support formica back-assy 51.3 x 10mm offset
( Start-Datun from 0:0 vice corner x=77.20 y=35.00
( Install 6mm Ball Nose Milling Cutter mounted in collet-chuck
( Spindle speed set to 2000~2500rpm
( operation begins automatically when quil TDC switch is opened
( raise the quill at the end of the last stroke
( with appropriate care the part can be removed during the parked condition
( 80% Kero+ 20% RTD used as cutting lubricant
( .
( datum is x = 24.5 mm, y = 25.0 mm, includes 2 mm to edge of extrusion
clr		( clear all existing programs/commands
p		( begin programme
m 1		( set motor to FULL step mode
t 100		( set start speed to 200 steps/sec
max 100	        ( set MAXimum motor speed to steps per sec. i.e. 400 steps/sec
a 500		( set acceleration to 500 steps/sec/sec
de 500          ( set deceleration to 1500 steps/sec/sec
k 50            ( sets step constant to 50 ?
s 4 0           ( BDC switch OPEN
s 4 1           ( check that the TDC/BDC switch is closed
o 1 1           ( mist lubrication ON
w 10            ( wait while quill is plunged into material
x 820           ( move "x" axis 8.2 mm
t 200           ( return start speed increased
max 900         ( return speed increased
a 1200          ( return acelleration increased
de 1200         ( return decelleration increased
o 1 0           ( mist lubrication OFF
s 4 0           ( check that the BDC/TDC switch is OPEN
x-820           ( return retracted travels at Max 900
c 0             ( turn motor current off
g               ( go to begining and repeat as often as job/parts require
q