( Digitech Heatsink SIDE drilling for 2.65mm M3 Roll Tapped Holes
clr		( clear all existing programms/commands
p		( begin programme
m 1		( set motor to FULL step mode
t 200		( set start speed to 300 steps/sec
max 1000	( set MAXimum motor speed to steps per sec. i.e. 1500 steps/sec
a 500		( set acceleration to 1500 steps/sec/sec
de 500		( set deceleration to 1500 steps/sec/sec
k 50            ( sets step constant to 50 ?
s 1 0           ( BDC switch OPEN - press is cycling or at TDC
s 1 1		( BDC switch CLOSED - identifies that punch is in the part
s 1 0           ( TDC switch OPEN - identifies that the Punching complete and disengauged from part
x 8380		( advance the leadscrew by 3683 steps = 36.83mm
s 1 0
s 1 1
s 1 0
x-8380