( CASA Heatshrink Cutter Feed-Bracket - Fixing holes
( .
( Set start reference datum at x+900, y+1200
( formica parallel thickness 20 mm upstand
( Install 5.5mm centre-drill
( spindle speed set to 1500rpm
( operation begins automatically when quil TDC switch is opened
( raise the quill at the end of the last stroke
( with appropriate care the part can be removed during the parked condition
( 80% Kero+ 20% RTD used as cutting lubricant
( .
( material datum is x = 0.00 mm, y = 0.00 mm
clr             ( clear all existing programs/commands
p               ( begin programme
m 1             ( set motor to FULL step mode
t 200           ( set start speed to 200 steps/sec
max 400 ( set MAXimum motor speed to steps per sec. i.e. 400 steps/sec
a 500           ( set acceleration to 500 steps/sec/sec
de 500      ( set deceleration to 1500 steps/sec/sec
k 50        ( sets step constant to 50 ?
s 4 0           ( BDC switch OPEN
s 4 1           ( check that the TDC switch is closed
o 1 1           ( mist lubrication on
s 4 0           ( BDC switch OPEN
o 1 0           ( mist lubrication off
y 2350          ( move "y" axis 23.50 mm
s 4 1           ( check that the TDC switch is closed
o 1 1
s 4 0           ( BDC switch OPEN
o 1 0
x 1600          ( move" x" axis 16.00mm
s 4 1           ( check that the TDC switch is closed
o 1 1
s 4 0           ( BDC switch OPEN
o 1 0
y-2350           ( move "y' axis 23.50mm
s 4 1           ( check that the TDC switch is closed
o 1 1
s 4 0           ( BDC switch OPEN
o 1 0
x -1600         ( move "x" axis 16.00mm
c 0             ( turn motor current off
g               ( go to begining and repeat as often as job/parts require
q