( File-Name: MP2UDCDM.ALS @ 12/07/05
( Alstom DCDM front panel - 180.9 x 45mm cut-out
( Install 3mm Short
( 2 passes are made
( and the 2nd pass finishing to the ( the travel concludes when the 2nd
( Spindle speed set to 5000rpm
( operation begins automatically when quill TDC
( raise the quill at the end of the X+13100mm stroke
( with appropriate care 13100 stroke
( 80% Kero+ 20% RTD cutting stroke ( return speed
( 
( ALSTOM DCDM Front Panels - 180.9 x 45mm cut-out
( Set start reference datum at x3650, y4525
( series Slot Drill or FC3 End Mill
( with the 1st roughing pass 0.2mm smaller final size
( pass reaches x=0.00; y=0.00
( switch is opened
( the part can be remove the part during the x
( used as
( cutting lubricant during the X+13100mm
( may be increased if justified by higher production rate
clr	  	( clear all existing programms/commands		
p 	  	( begin programme		
m 1	  	( set motor to FULL step mode		
t 100	  	( set start speed to 100 steps/sec
max 250 	( set MAXimum motor speed to steps per sec. i.e. 250steps/sec				
a 100	  	( set acceleration to 100 steps/sec/sec
de 300	( set deceleration to 300 steps/sec/sec
k 50		( sets step constant to 50 ?
s 4 0		( check that the TDC switch is closed
s 4 1 	( check BDC switch OPEN - mill may be cycling or at TDC
w 30		( wait 1/2 sec. - allows operator to plunge quill and penetrate the sheet
o1 1		( turn ON mist/spray
x 20		( move "x" axis +0.20mm - for finishing cut
y 20		( move "y" axis +0.20mm - for finishing cut
x 17750	( move "x"	axis	+177.90mm
y 4160	( move "y"	axis	-42.00mm
x-17750	( move "x"	axis	-177.90mm
y-4160	( move "y"	axis	42.00mm
o1 0		( turn OFF mist/spray
s4 0		( check that the TDC switch is closed
s4 1		( check BDC switch OPEN - mill may be cycling or at TDC
w30		( wait 1/2 sec. - remove off-cut from within recess
x-20		( move "x" axis -0.20mm - for roughing cut
y-20		( move "y" axis -0.20mm - for roughing cut
max 350 	( set MAXimum motor speed to steps per sec. i.e. 350 steps/sec
x 17790	( move "x"	axis	+177.90mm
y 4200	( move "y"	axis	-42.00mm
x-17790	( move "x"	axis	-177.90mm
y-4200	( move "y"	axis	42.00mm
o 1 0		(	turn OFF mist/spray
S 4 0		( BDC switch CLOSED - identifies that quill is retracted
c 1		( turn motor current off
g		( go to beginning and repeat as often as job/parts require
		(
		( after-load characters to ready the above programme:
		( Q
		( S