( CASA Rack Fixing Holes for Instrument and Abbey Boxes
( Set start reference datum at x1050, y0650
( Orient the part with 1" flange towards the open end of the vice
( Install 4mm Short series Slot Drill or End Mill
( Spindle speed set to 2500rpm
( operation begins automatically when quil TDC switch is opened
( 80% Kero+ 20% RTD used as cutting lubricant during the X+13100mm cutting stroke
clr		( clear all existing programms/commands
p		( begin programme
m 1		( set motor to FULL step mode
t 200		( set start speed to 300 steps/sec
max 400	        ( set MAXimum motor speed to steps per sec. i.e. 1500 steps/sec
a 500		( set acceleration to 1500 steps/sec/sec
de 500		( set deceleration to 1500 steps/sec/sec
k 50            ( sets step constant to 50 ?
s 1 0           ( check that the TDC switch is closed
s 1 1           ( BDC switch OPEN - press is cycling or at TDC
s 1 0           ( check that the TDC switch is closed
x 2050          ( move "x" axis +20.50mm
s 1 0
s 1 1
s 1 0
y 3070          ( move "Y" axis +30.70mm
s 1 0
s 1 1
s 1 0
x-2050          ( move "x" axis -20.50mm
S 1 0		( BDC switch CLOSED - identifies that punch is in the part
s 1 1
s 1 0
y-3070          (move "Y" axis 30.70mm
c 1             ( turn motor current off
g               ( go to begining and repeas as often as job/parts require