General
|
| Manufacturer |
Manufactured for Dell |
|
| Model number |
PowerVault 110T DLT VS160 |
| Interface type |
16-bit Wide-Ultra 160 SCSI Low-Voltage Differential
(LVD). Also compatible with a Single-Ended (SE) bus |
|
|
Performance
|
| Formatted capacity, without data compression |
80GB of User Data |
|
| Formatted capacity, with data compression |
160GB of User Data assuming 2:1 compression |
|
| Type of compression |
Hardware DLZ |
|
| Effective backup rate |
8.0MB/second without data compression
Up to 16.0MB/second with data compression, 2:1 compression ratio typical |
|
| Raw data transfer rate |
>8.0MB/second (includes format data, user data,
post amble, etc.) |
| Tape speed, Read/write |
122 inches per second |
|
| Tape speed, Search/rewind |
160 inches per second |
|
| Load time from BOT for previously recorded cartridge |
80 seconds |
|
| Recording method |
PRML |
|
| Recording media |
DLTtape VS1 |
|
| Cartridge size |
4.1 inch x 4.1 inch x 1.0 inch |
|
| Data density |
175 Kbpi (linear bit density) |
|
| Tracks |
60 Logical Tracks, 240 physical tracks |
|
|
|
Reliability
|
| Recording unrecoverable errors |
1 in 1017 |
|
| MTBF |
250,000 hours
Dell Computer Corporation does not warrant that predicted MTBF is representative
of any particular unit installed for customer use. Actual figures vary from
unit to unit. (MTBF is measured at 100% duty cycle, excluding head life.) |
|
|
Recommended Tapes
|
| Type of Tape |
Manufacturer |
|
| DLTtape VS1 |
Dell branded media
|
|
| Cleaning |
Dell branded |
|
|
|
Physical
|
| Specification |
PowerVault 110T DLT VS160 Tape Internal |
PowerVault 110T DLT VS160 Tape External |
| Height |
1.618 in (41.1 mm) without bezel
1.656 in (42.06 mm) with bezel |
2.608 in (66.24 mm) |
| Width |
5.748 in (146 mm) behind bezel
5.807 in (147.5 mm) with bezel |
8.352 in (212.13 mm) |
| Depth |
8.571 in (217.7 mm) measured from back of front
bezel
8.770 in (222.76 mm) including the bezel |
10.728 in (272.49 mm) |
| Weight |
3.0 lbs (1.36 Kg) |
8.0 lbs (3.63 Kg) |
|
|
Power
|
| Specification |
PowerVault 110T DLT VS160 Tape Internal |
PowerVault 110T DLT VS160 Tape External |
| Voltage |
+5VDC, +12VDC |
100-240VAC (auto-ranging), 50/60Hz |
| Voltage tolerance |
± 5% |
N/A |
| Operational current |
1.2A Typical @ +5VDC
0.5A Typical @ +12VDC |
0.9A |
| Peak |
1.9A @ +5VDC, ~300ms duration
2.7A @ +12VDC, ~300ms duration |
N/A |
| Power use (nominal) |
DC 11.5W steady state, > 14W maximum |
> 35W |
|
|
Environmental
|
| Specification |
Operating |
Storage |
| Temperature |
10 to 40 degrees C |
-40 to 66 degrees C |
| Thermal gradient |
11 degrees C/h (across range) |
20 degrees C/h with 5 degree margin (across range) |
| Relative humidity |
20% to 80% noncondensing |
10% to 95% noncondensing |
| Maximum wet bulb temperature |
25 degrees C |
46 degrees C |
| Altitude |
-500 to 30,000 feet |
-500 to 30,000 feet |
| Shock |
5g @ 11 ms, 62g @ 2 ms |
142g @ 2 ms |
