Reboot options

If you set the reboot options on the Review/Install Updates screen, they are set for all the targets. If you want to set the reboot options for only specific targets, click Select Bundles or Select Components for the target, and then click Reboot Options for the target.

[Note]

NOTE: For Superdome 2 servers, the reboot options are set for each partition on the Select Devices screen. HP SUM does not support global reboot options for Superdome 2 servers.

To set the reboot options:

  1. Click Reboot Options.

  2. Check Reboot System After Installation to set the reboot.

  3. Check If Needed or Always.

  4. Click OK.

    [Note]

    NOTE: Reboot Delay and Reboot Message do not apply for Integrity servers.