IBM Automatic Server Restart (ASR) Application for IPMI on Windows

(C) Copyright International Business Machines Corporation 1999, 2008. All rights reserved.
US Government Users Restricted Rights - Use, duplication, or disclosure restricted by GSA 
ADP Schedule Contract with IBM Corp.

Note: Before using this information and the product it supports, read the general information 
in "Notices and trademarks in this document.


CONTENTS
________
1.0  Overview
2.0  Installation and setup instructions
3.0  Configuration information
4.0  Web information and support phone number
5.0  Trademarks and Notices
6.0  Disclaimer


1.0  Overview
_____________
        1.1   This package contains IBM ASR-IPMI application for Windows that runs on
              xSeries servers and blades running Windows Server 2003 R2 or Windows
	      Server 2008.

        1.2   Limitations

              - N/A

        1.3   Enhancements

              - N/A

        1.4   Level of Recommendations and Prerequisites for the Update:

              - N/A

        1.5   Dependencies:

              Before installing this software, make sure Microsofts IPMI driver
	      (IPMIDrv.sys) is installed on your system.

              - Windows Server 2008:
                The IPMI driver will be loaded automatically by the OS if the
                Baseboard Management Controller (BMC) is detected.  Look for
                "Microsoft Generic IPMI Compliant Device" in the Device Manager
                under "System Devices", to confirm BMC detection.  If the device
                is not listed, check for BIOS updates for your system.

              - Windows Server 2003 R2:
                You will need to install the Hardware Management component found in
                Add/Remove Programs->Add/Remove Windows Components->Management and
                Monitoring Tools.  Upon installing the Hardware Management component
                you may receive a warning to remove all other IPMI drivers.  This is
                necessary to avoid driver conflicts.  

                In some cases it is necessary to manually create the BMC IPMI deivce
                in Device Manager.  With the Hardware Management component installed,
                look for "Microsoft Generic IPMI Compliant Device" in the Device
                Manager under "System Devices".  If the device is not listed, you
                should run the following from a command session:

                    Rundll32 ipmisetp.dll, AddTheDevice

                This will manually create the BMC IPMI device in the Device Manager
                and cause the driver to be loaded.

              
2.0   Installation and Removal Instructions
_________________________________________

        2.1   Installation steps:

              Execute the IBM IPMI ASR package (ibm_utl_asr_wap9XXa_winsrvr_i386.exe, 
              where XX is the current version of the executable package).

              Follow the directions that appear on the screen.


        2.2   Installation steps for unattended mode

              Run the IBM IPMI ASR package with parameters as shown below, where XX is 
              the version of the executable package. 
                     
                ibm_utl_asr_wap9XXa_winsrvr_i386.exe -s -install -n


        2.3   Uninstall steps:

              Run the IBM IPMI ASR package with parameters as shown below, where XX is 
              the current version of the executable package. 
                
                ibm_utl_asr_wap9XXa_winsrvr_i386.exe -s -remove


3.0   Configuration Information
_______________________________

        3.1   The restart timer defaults to a value of 255 seconds.  If a system with a large 
              amount of memory is configured to perform a complete memory dump in the event of 
              a system failure, then the default timeout value may cause the system to restart 
              before the memory dump is complete.  To set a customized value for the restart 
              timer, run the IBM IPMI ASR package with parameters as shown below, where XX is 
              the current version of the executable package, and ZZZZ is a numeric value between
              250 and 3200 representing the number of seconds following a system failure before
              the server is rebooted.
              
                ibm_utl_asr_wap9XXa_winsrvr_i386.exe -install -ZZZZ

              For unattended configuration of the timer issue the following command:

                ibm_utl_asr_wap9XXa_winsrvr_i386.exe -s -install -n -ZZZZ


4.0     Web information and support phone number
________________________________________________

        4.1   IBM Support Web Site:
              http://www.ibm.com/support/.
                
              For a list of supported operating systems on legacy (non-shipping) 
              controllers, see http://www.ibm.com/servers/eserver/serverproven/compat/us/.

              You can receive hardware service through IBM Services or through your IBM
              reseller, if your reseller is authorized by IBM to provide warranty service. See
              http://www.ibm.com/planetwide/ for support telephone numbers, or in the U.S.
              and Canada, call 1-800-IBM-SERV (1-800-426-7378).

              In the U.S. and Canada, hardware service and support is available 24 hours a day,
              7 days a week. In the U.K., these services are available Monday through Friday,
              from 9 a.m. to 6 p.m.


        4.2   IBM eserver xSeries Web Site:
              http://www.ibm.com/eserver/xseries

        4.3   If you have any questions about this update, or problems applying the update, 
              go to the following Help Center World Telephone Numbers and URL:
              http://www.pc.ibm.com/qtechinfo/YAST-3P2QYL.html.


5.0     Notices and trademarks 
______________________________

        5.1   The following terms are trademarks of the IBM Corporation in the United States 
                            or other countries or both:

                -  IBM

        5.2   The following terms are trademarks of the Microsoft Corporation in the United 
                            States or other countries or both:

                -  Windows
                -  Windows 2000
                -  Windows Server 2003
		-  Windows Server 2008


6.0     Disclaimer
__________________

        6.1   THIS DOCUMENT IS PROVIDED "AS IS" WITHOUT WARRANTY OF ANY KIND.  IBM DISCLAIMS
              ALL WARRANTIES, WHETHER EXPRESS OR IMPLIED, INCLUDING WITHOUT LIMITATION, THE 
              IMPLIED WARRANTIES OF FITNESS FOR A PARTICULAR PURPOSE AND MERCHANTABILITY WITH 
              RESPECT TO THE INFORMATION IN THIS DOCUMENT.  BY FURNISHING THIS DOCUMENT, IBM
              GRANTS NO LICENSES TO ANY PATENTS OR COPYRIGHTS.
