SMA connector

From Wikipedia, the free encyclopedia

Jump to: navigation, search

Figure 1) Standard male SMA plug connector: SMA-M with male contact

An embedded RouterBoard 112 with U.FL-RSMA pigtail and R52 mini PCI Wi-Fi card widely used by wireless Internet service providers (WISPs) in the Czech Republic.

SMA (SubMiniature version A) connectors are coaxial RF connectors developed in the 1960s as a minimal connector interface for coaxial cable with a screw type coupling mechanism. The connector has a 50 Ω impedance. It offers excellent electrical performance from DC to 18 GHz.

Contents

1 Connector design
2 Variations
3 Reverse polarity SMA
4 See also
5 References
6 External links

[edit] Connector design

The SMA connector consists of a 0.250x36 thread. The male is equipped with a .312 inch hex nut. It is important that the nut be properly torqued with a 5/16 inch wrench, 3-5 in·lbf (0.3 to 0.6 N·m) for brass, and 7-10 in·lbf (0.8–1.1 N·m) for stainless steel connectors. When turning the nut, it is very important that the remainder of the connector does not rotate, otherwise premature wear of the connector will result. Furthermore, the connector should be carefully inspected before each use, and any debris cleaned with compressed air. When properly handled, a SMA connector should remain within specified performance through 500 mating cycles.

The SMA connector uses a polytetrafluoroethylene (PTFE) dielectric which will contact along the mating plane. Variablilty in the construction and the mating of the connectors limit the repeatability of the connector impedance. For that reason, a SMA connector is not a good choice for metrological applications.

The outer shell of the male or plug connector has an inside thread and an inner pin, which can be confusing. In conventional SMA, the terms "male" and "female" refer exclusively to the inner pin or socket of the connectors. The male connector is also commonly referred to as a "plug", whereas the female connector is also known as a "socket" or "jack".

[edit] Variations

The SMA connector is typically rated for mode-free operation from DC to 18 GHz, though some proprietary versions are rated to 26.5 GHz. For performance above this, SMA-like connectors are used. These are the 3.5 mm connector, rated to 34 GHz, and the 2.92 mm, good up to 46 GHz. These connectors keep the same outside thread as the SMA, so they can all be cross-mated, however they use an air dielectric, with the center conductors appropriately scaled. However, the life of the precision connector will be reduced, and can be easily damaged when mating with low-grade SMA connectors.

Beyond 46 GHz, the 2.4 mm, 1.85 mm and the 1 mm connector exist. These are similar to the SMA connector, but with the geometries incompatibly scaled. These have mode-free operation to 50, 65, and 110 GHz respectively.

Figure 2) Proprietary female RP-SMA jack connector: RP-SMA-F with male contact

[edit] Reverse polarity SMA

Reverse polarity SMA (RP-SMA or RSMA) is a proprietary variation of the SMA connector specification which reverses the gender of the interface, as shown in Figures 1 and 2.

There is much confusion caused by the terms 'male' and 'female' with reversed connectors. These are best avoided and instead the correct terms plug and jack should be substituted.

The RP-SMA plug connector has the same external housing as a standard or conventional SMA plug connector, which consists of an outer shell with the thread on the inside; however, the internal prong or pin is replaced by a receptacle or female inner pin. The RP-SMA jack connector as shown in Fig 2 has the same housing as a standard or conventional SMA jack connector, thread on the outside, however the female receptacle is replaced by a male prong or pin.

RP-SMA connectors are widely used by Wi-Fi equipment manufacturers to comply with specific local regulations, e.g. the FCC, which are designed to make it difficult for consumers to connect antennas with gain and thereby breach compliance.

The term "reverse polarity" might appear confusing to some non-WiFi RF engineers, as polarity elsewhere in RF literature can refer to the electromagnetic polarity, not to a change of gender (in this case replacing the prong for a receptacle and vice-versa).

[edit] See also

SMB connector
SMC connector
TNC connector, also has RP-TNC version used for Wi-Fi

[edit] References

Radio-frequency connectors. Part 15: R.F. coaxial connectors with inner diameter of outer conductor 4.13 mm (0.163 in) with screw coupling — Characteristic impedance 50 ohms (Type SMA). International Standard IEC 60169-15, 1979.
CECC 22110/111
Connectors, plug, electrical, radio frequency. Military specification sheet MIL-C-39012.

[edit] External links

RF Connectors from WA1MBA

| Wikimedia Commons has media related to: Connectors

v • d • e

RF connectors

N · BNC · TNC · F · SMA · SMB · SMC · TV Aerial Plug · MMCX · MCX · FME · C · UHF · GR · Motorola · Musa · Mini-UHF · QMA/QN · APC-7 · EIA · Hirose U.FL

Retrieved from "http://en.wikipedia.org/wiki/SMA_connector"

Category: Coaxial connectors

Views

Article
Discussion
Edit this page
History

Personal tools

Log in / create account

Navigation

Main page
Contents
Featured content
Current events
Random article

Search

Interaction

About Wikipedia
Community portal
Recent changes
Contact Wikipedia
Donate to Wikipedia
Help

Toolbox

What links here
Related changes
Upload file
Special pages
Printable version
Permanent link
Cite this page

Languages

Deutsch
Español
עברית
Polski
Svenska

This page was last modified on 27 January 2009, at 20:02.
All text is available under the terms of the GNU Free Documentation License. (See Copyrights for details.)
Wikipedia® is a registered trademark of the Wikimedia Foundation, Inc., a U.S. registered 501(c)(3) tax-deductible nonprofit charity.

Privacy policy
About Wikipedia
Disclaimers